Seachem Phosbond 100ml in a Bag - Phosphate and Silicates

Seachem Phosbond 100ml in a Bag - Phosphate and Silicates

Seachem Phosbond will remove phosphate and silicates utilising GFO and Alumina Oxide hybrid.

PhosBond is a revolutionary new product that combines the phosphate removing capabilities of both aluminium oxide and granular ferric oxide into a singular material forming a synergistic effect.

It rapidly removes phosphates and silicates from saltwater and freshwater, combining the best of both types of phosphate removers.

Its high porosity and surface area give it a large binding capacity, while its physical strength and integrity assures that it will not break down from mechanical stress.

Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest Phosphate or MultiTest Silicate.

If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosBond, otherwise leave in place until levels begin to climb again.

As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended.

PhosBond is not an exchange resin and does not release anything into the water.

It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted.

Continuous use of small quantities is better than intermittent use of larger quantities.